IDP "Flat-line" trigger for Glocks
SKU:
$95.00
$80.00 - $95.00
$85.00
On Sale
Introducing the IDP Tactical flat faced "Flat-line" trigger for Glocks (Gen 3 - 4)
Precision machined from 6061 aircraft grade aluminum and coated in MIL Spec hard anodize, our new flat face trigger is machined as a non adjustable trigger for reduced takeup, overtravel and quick reset! Our triggers work best right out of the box with your factory trigger bar on a non modified firearm. Enjoy the benefits of a custom trigger job to give your Glock® a smooth pull, clean release, and short reset. Whether used for competition, carry or duty, our trigger is the ideal off the shelf part for that custom trigger job "feel" you are looking for.
The IDP "Flat-line" Trigger Kit contains: a fully assembled trigger pad and trigger safety with a "started" roll pin (partially installed) ready to be inserted thru your factory trigger bar.
Note: Using your factory trigger requires you to replace (break out) your plastic factory trigger from the factory trigger bar. There are installation videos on our you tube page for guidance.
SOME GLOCK TRIGGER BARS HAVE VARYING TOLERANCES AND MAY NOT PROPERLY ENGAGE THE STRIKER. WHILE RARE, THIS CAN OCCUR. This product should ONLY be installed, fit and tested by Glock certified gunsmiths. All gunsmiths must check for proper engagement between the crucifix and striker pedestal ( 2/3 to full engagement ).USER ASSUMES ALL RISKS ASSOCIATED WITH INSTALLATION AND USE.
Precision machined from 6061 aircraft grade aluminum and coated in MIL Spec hard anodize, our new flat face trigger is machined as a non adjustable trigger for reduced takeup, overtravel and quick reset! Our triggers work best right out of the box with your factory trigger bar on a non modified firearm. Enjoy the benefits of a custom trigger job to give your Glock® a smooth pull, clean release, and short reset. Whether used for competition, carry or duty, our trigger is the ideal off the shelf part for that custom trigger job "feel" you are looking for.
The IDP "Flat-line" Trigger Kit contains: a fully assembled trigger pad and trigger safety with a "started" roll pin (partially installed) ready to be inserted thru your factory trigger bar.
Note: Using your factory trigger requires you to replace (break out) your plastic factory trigger from the factory trigger bar. There are installation videos on our you tube page for guidance.
SOME GLOCK TRIGGER BARS HAVE VARYING TOLERANCES AND MAY NOT PROPERLY ENGAGE THE STRIKER. WHILE RARE, THIS CAN OCCUR. This product should ONLY be installed, fit and tested by Glock certified gunsmiths. All gunsmiths must check for proper engagement between the crucifix and striker pedestal ( 2/3 to full engagement ).USER ASSUMES ALL RISKS ASSOCIATED WITH INSTALLATION AND USE.
Only a few left!
